63583 QUICK START GUIDE WARNING To prevent serious injury, read manual warnings and instructions before use. Assemble face shield handle and cover handle. Knob Install FLUX-CORE wire spool. Insert wire through both wire liners and clamp it into feed mechanism. See manual if changing wire size. Spring Top Plate Wire Spool Spindle welding wire 2" Take off nozzle and tip, plug in welder, turn it on, and squeeze trigger until wire comes out. WARNING To prevent fire and serious injury: Nozzle Incrementally tighten wire feed tension knob clockwise until wire will bend from feed tension at 2"-3". " 0″ .03 clockwise Contact Tip 2"- 3 Keep torch and wire clear of grounded objects while welder plugged in. Wire Spool wood block GUN 90 AMP FLUX WIRE WELDER ITEM 68887 Unplug welder and replace nozzle and tip. Adjust wire feed speed and MAX/MIN settings according to chart. ON MIN I O OFF WIRE FEED SPEED GUN MAX Specifications Wire 0.030″- 0.035″ Flux-Core Capacity 18 Ga. – 3/16″ Steel Plate Weldable Mild, Low Alloy Steel Materials (Not for Aluminum or Stainless Steel) GROUND 120V~ 60Hz 20A HOLD GUN CLEAR 90 AMP FLUX WIRE WELDER Hold gun clear of workpiece, then plug in welder and turn it on. ITEM 68887 ON MIN I O OFF WIRE FEED SPEED MAX Specifications Wire 0.030″- 0.035″ Flux-Core Capacity 18 Ga. – 3/16″ Steel Plate Weldable Mild, Low Alloy Steel Materials (Not for Aluminum or Stainless Steel) GROUND 17e BASIC WELDING INSTRUCTIONS AND WELDING TIPS ARE IN MANUAL. Downloaded from www.Manualslib.com manuals search engine 120V~ 60Hz 20A Downloaded from www.Manualslib.com manuals search engine Specifications OFF O I ON 120V~ 60Hz 20A WIRE FEED SPEED GROUND MAX MIN TO CORRECT: Wire 0.030″- 0.035″ Flux-Core Capacity 18 Ga. – 3/16″ Steel Plate Weldable Mild, Low Alloy Steel Materials (Not for Aluminum or Stainless Steel) ITEM 68887 Current Too High or Wire Feed Too Fast MAX MIN GROUND WIRE FEED SPEED 120V~ 60Hz 20A or Specifications OFF O I ON 120V~ 60Hz 20A Weld Speed Too Fast MAX MIN weld slower TO CORRECT: Wire 0.030″- 0.035″ Flux-Core Capacity 18 Ga. – 3/16″ Steel Plate Weldable Mild, Low Alloy Steel Materials (Not for Aluminum or Stainless Steel) ITEM 68887 90 AMP FLUX WIRE WELDER Specifications OFF O I GUN ON TO CORRECT: Wire 0.030″- 0.035″ Flux-Core Capacity 18 Ga. – 3/16″ Steel Plate Weldable Mild, Low Alloy Steel Materials (Not for Aluminum or Stainless Steel) ITEM 68887 90 AMP FLUX WIRE WELDER Current Too Low 90 AMP FLUX WIRE WELDER WIRE FEED SPEED GROUND GUN Good Weld GUN weld faster TO CORRECT: Weld Speed Too Slow maintain less than 1/2" stickout TO CORRECT: Stickout Too Long Flux-core welds will have a coat of slag over them until cleaned. CLEAN WELDS FIRST! 63583 WELD EXAMPLE PICTURES
