Additional Resources domestika.org Course by En•Concreto TECHNICAL SPECIFICATIONS OF SEALERS Brands and generic names of the products. Additional Resources – En•Concreto domestika.org VINYL ADHESION PROMOTER TYPE OF SEALER RECOMMENDED FOR REINFORCING THE MIX DESCRIPTION Vinyl adhesion promoters to add to adhesives, mortar, binders, slurries and textured surfaces; as well as a sealer for concrete surfaces or plaster to put on putty, stucco, plaster or textured surfaces. Increases the work time, hardness, adhesiveness and resistance to CEMENT APPLICATION AS AN ADHESION PROMOTER friction and wear. Noticeably decreases permeability, allows new cement to bond to old cement. Resistant to alkaline pHs. 1. Put water in a container along with Glue and Pegaduro Sealer 2. Add a 20 Kg sack of Pegaduro Product → link to the product’s fact sheet 3. Mix well until you get a homogeneous paste, without any lumps 4. Let the mix rest for 10 minutes. Stir it again and use it. Don’t add any more water. Additional Resources – En•Concreto 100% ACRYLIC ADDITIVE TYPE OF SEALER RECOMMENDED FOR REINFORCING THE MIX AND MAKING REPAIRS domestika.org • Perfect for binding on flat ground and to improve binding when installing low or zero absorption coatings, like glass, porcelain and marble. • It can also be used to seal walls and roofs. DESCRIPTION: This is a 100% acrylic additive to use with cement-based mortars. It APPLICATION enhances the physical properties of the product that it’s mixed with, Shake the product before use, add it to the mortar slowly, and mix it to adding more adhesion and strength. keep lumps from forming. After, add the right amount of water until a thick uniform paste forms. Let it sit for 5 minutes, mix it again without ADVANTAGES adding more liquid and so it’s ready to use. Use the same amount of Adds strength and hardness to different mortars increasing the adhesion water and Duracril Perdura in each mix that you prepare. The amount of of the mix. Minimizes the contraction / expansion of the materials and Duracril Perdura required in the mix varies depending on the needs. improves water resistance. USES • As an additive to mortar, concrete, adhesive, stucco, slurry and binder mixes. • To bind new concrete to old concrete, in mixes with adhesives. → link to the product’s fact sheet Additional Resources – En•Concreto WATER-BASED SILICONE COATING domestika.org • Allows the surface to breathe and frees retained water vapor • Stops saltpeter from forming (efflorescence) TYPE OF SEALER RECOMMENDED FOR FINAL PROTECTION • Reduces corrosion, chipping and damage due to freezing and unfreezing FINISH: • Easy to apply Natural finish, transparent • Interior and exterior use on horizontal and vertical concrete and masonry surfaces without finishes like: concrete, brick, mosaics, tile, WHERE ITS USED aggregates, pavers, stone and cement Interior and exterior use on horizontal and vertical concrete and masonry surfaces without finishes like: concrete, brick, mosaics, tile, aggregates, pavers, stone and cement. KEY BENEFITS: • Impregnating water-based silicone covering • Forms a barrier on the surface that keeps the water out • Keeps water from getting in, salt and fungus • High penetration sealer, up to 12 mm • Transparent finish that doesn't change the appearance of the substrate → link to the product’s fact sheet
