28/10/2019
Updating Files for Mastercam 2019 (Migration Wizard)
QTE Manufacturing Solutions
Updating Files for Mastercam 2019
(Migration Wizard)
There is a tool to update files to the nest version of Mastercam. You don't need to Migrate
everything, and doing a "Basic Migration" may cause problems depending on how Mastercam
was setup and configured. Using the "Advanced Migration" option will stream line what you
need, and is the recommended way to transition.
First you need to activate the "Migration Wizard" by going through "File" down to "Convert" then
selecting "Migration Wizard"
1/6
28/10/2019
Updating Files for Mastercam 2019 (Migration Wizard)
Once the "Migration Wizard" starts, select "Advanced" and on the next page, make sure the "Source
folder is correct", then make sure the "Destination Folder" is also correct, then click on "Next"
2/6
28/10/2019
Updating Files for Mastercam 2019 (Migration Wizard)
3/6
28/10/2019
Updating Files for Mastercam 2019 (Migration Wizard)
Click in the box next to "File Types" to unselect everything, then select the desired file types, shown are
the file types for migrating the post processors. I recommend doing the post processor by first, the
migrating the rest of the desired files.
Under "Versions" leave all versions active, in case there was an old file in the newer directory, and it
won't erase or overwrite the old files.
4/6
28/10/2019
Updating Files for Mastercam 2019 (Migration Wizard)
The last page is a break down of what will be migrated, if everything looks correct, click "Finish"
5/6
28/10/2019
Updating Files for Mastercam 2019 (Migration Wizard)
https://support.zoho.com/portal/qtemfg/kb/articles/migr
6/6
0
