ISTRUCTIONS FOR INSTALLATION, USE AND MAINTENANCE FOR P-NP-XP-NE SERIES D.C. MACHINES 10. DEMONSTRATION GEBNERAL DRAWINGS AND NOMENCLATURE 01 Complete rotor 02 Rotor coil 03 Commutator 04 Shaft 05 Shaft end key 50 Terminal box frame 51 Terminal box lower seal 52 Terminal board header 53 Terminal box lid seal 54 Terminal box lid 10 Complete stator 11 Main pole bobbin 12 Auxiliary pole bobbin 13 Auxiliary pole bobbin terminal 14 Main pole bobbin terminal 15 Identification plate 60 Electric fan 61 Asynchronous motor 62 Filtering panel 63 Filter-holder frame 70 Screw Fasteners for fixing the shield to the stators 71 Brush terminal cover screw fasteners 72 Brush-holder box screw fasteners 73 Lifting eye-bolts 74 Filtering unit nut fasteners 75 Electric fan screw fasteners 76 Lateral hatch screw fasteners 77 Screw Fasteners for fixing the frame box to the shield 78 Screw fasteners for fixing terminal box to box frame 79 Nuts for power supply terminals 80 Terminal board header screw fasteners 81 Terminal box lid screw fasteners 82 Brush-holder ray fixing screws 20 Drive end shield 21 Commutator end shield 22 Drive end bearing 23 Commutator end bearing 24 Rispan 30 Brush-holder ray 31 Brush-holder box 32 Brush 33 Brush terminal cover 40 Finned hatch 42 Commutator end lateral seal 43 Commutator end lateral hatch 44 Commutator end upper shield seal 45 Drive end upper shield seal Fig. 10.1 – Demonstration general drawing for sizes P-NP 80-112 Sicme Motori SpA – Strada del Francese 126/130 – 10156 Turin – Italy Tel. +39-011-4076311 - Fax +39-011-4500047 – www.sicmemotori.com – [email protected] M-CC-80-800-E-05 47