ZSK Stickmaschinen GmbH Postfach 102461, D-47724 Krefeld Final Inspection - Quality control Presser foot / Cam disk Presser foot height: 0,7 mm Cam disk adjusted: 136 degrees Trip cam on the upper shaft for colour change release Switching phase Left: Right: START degrees Switching phase Left: Right: END degrees Adjustment of gripper hook Needle rise: 203,0 degrees = Needle depth: 2 mm 1 mm Needle; gripper hook distance: 0,05 - 0,2 mm Retaining finger distance: 0,7 mm Machine Service Pantograph start: 255 degrees Pantograph start W-head: degrees Upper thread monitor ON: 48 degrees Upper thread monitor OFF: 51 degrees Lower thread monitor ON: 0 degrees Lower thread monitor OFF: 100 degrees Sequin transport ON: degrees Upper thread trimmer before cutting: 315 degrees Z axes start: degrees Z axis sector: degrees Thread trimming, picker OFF: degrees Thread trimming, catcher START: degrees Needle position: 85 degrees Controlled thread feed start: degrees Software Machine type: JAFA 0412-400 Software version: T8 Terminal Software 02.03.2013 Final Inspection Machine-No.: 26851 Date: 13. August 2013 T8 operating system Engl.Vers. 01.12.2011 5100 V40 AW F 09.07.2013